|
|
|||||||||||||||||||||||||||||
|
|||||||||||||||||||||||||||||
|
SUNDRIES |
|||||||||||||||||||||||||||||
|
Microfiber
Cloths
Millions of microscopic non-abrasive fibers per towel,
Non-abrasive, Lint-free, Extremely Durable - lasts for hundreds of
washings. Super-Absorbent -
holds 7 times it’s weight in liquid – uses capillary action to absorb.
Chamois can drag debris along surface of paint - Microfiber
reduces/eliminates potential by trapping dirt/dust/debris into the deep
pile of the cloth.
|
|
||||||||||||||||||||||||||||
|
______________________________________ |
|||||||||||||||||||||||||||||
|
Stainless
Steel Activator Stainless
steel has the peculiarity of not plating with conventional plates, such as
nickel or copper. So, it needs this special priming system.
Use our Stainless Steel Activator product with a nickel anode in an
electroplating system. Plate
the part in the Stainless Steel Activator solution, with a nickel anode
for one minute at room temperature. Use 1 amp per 15 square inches of
surface area. The
process is detailed in our Complete Plating Manual. |
|
||||||||||||||||||||||||||||
|
__________________________________________________________________________________________________________
|
|||||||||||||||||||||||||||||
|
Stainless Steel Blackener 370 is an acidic liquid concentrate used full strength or diluted with up to 3 parts water to blacken stainless steel at room temperature. Recommended for color coding parts and blackening engravings on stainless steels. Produces a pleasing dark gray/black finish. |
|
||||||||||||||||||||||||||||
|
_____________________________________________________________________________________________________________
|
|||||||||||||||||||||||||||||
|
To carry out repairs to pits, simply bead blast the
part, and clean the pits of black corrosion. If the pits are deep or big, under-fill them with epoxy filer or some
other suitable car body filler. Ensure you leave a little room for some
PITSTOP™ over the top of the filler. This two step process will
economize on the PITSTOP™ application.
Fill the
deeper areas with epoxy filler. Allow to cure, then sand the area lightly. This
will ensure you have slightly under-filled the holes. Squeeze out equal quantities of PITSTOP™ and mix
thoroughly. Apply with the spatula pick supplied in a smooth, even layer,
and allow to cure. You may need to sand down the repair, so do it with 600
grit paper, ensuring you do NOT cut through the PITSTOP
PITSTOP™ is ideal for parts that have been copper plated, and those annoying black pits are still showing through. Simply clean the effected area (Light bead blast, abrade, etc) and apply a thin layer of PITSTOP™ over the offending area, then re-plate with copper. |
|
||||||||||||||||||||||||||||
|
_____________________________________________________________________________________________________________
|
|||||||||||||||||||||||||||||
| _______________________________________________________________________________________________________________________ | |||||||||||||||||||||||||||||
|
Wet
& Dry Paper Silicon Carbide Wet & Dry Paper gives you exceptionally long life with increased cutting power.
|
||||||||||||||||||||||||||||
| ________________________________________________________________________________________________________________________ | |||||||||||||||||||||||||||||
 |
Airbrush
Set
Perfect
for the application of Silvaspray conductive coating, Black Satin Exhaust
Paint or Copper Conductive
Paint
Packaging may change
|
|
|||||||||||||||||||||||||||
