Black Oxide Gel

1.00 KGS

Out of stock

Product Overview

                                                                        BLACK OXIDE GEL FOR MILD STEEL

blk-oxd-parts.jpgThis is a consumable for our Black Oxide Gel Kit, but can be bought on its own if you intend not to use the beeswax. Very simple to apply, and being a Gel it will not run, and is good for applying to fixed structures were there is a need to blacken on the underside of an item, as it will stick easily

As with all Patina products the finish will only be as good as the preparation, therefore its important Clean and remove any grim from the surface prior to applying, room temperature will need to be a minimum of 27°c.

On flat surfaces its difficult to get a complete even finish, as this can normally only be achieved by dipping in Black Oxide Solutions, but with even amounts applied and even weight distribution when polishing you will achieve a good black surface

If the surface is cleaned with Thinners, you are also able to get Artisitic effects which you can experiment with, this product is also good for touching in areas of black oxide that have become damaged.

After you have applied the product, simply rinse of and then apply a sealer



Please note that our shipping prices are a higher than it would cost to send a normal parcel via the post,
the reason for this is because any product that contains chemicals must be sent and packed as per the
"hazardous goods" regulations, and be transported by a carrier that is licensed to be able to transport.
We are unable to send by regular post as it is now a criminal offence to send undeclared hazardous goods, for postage rates please click on the tab above


If you are a VAT Registered company in Mainland Europe, when completing the "New Account" form at checkout, as seen below, please enter your European VAT Number, it will then be verified direct with the EU Commission website, and you will not be charged VAT on your order.