Silvaspray™
NOW, you can plate all plastics and non-conductives’
easily!
Silvaspray™ is the product we’ve been waiting
for!!
Simply spray on Silvaspray™, allow to dry and plate.
Directly accepts Bright Acid Copper, Copy Chrome, Nickel.
(Not recommended for
Electroless Nickel/ Krome due to heat, Brush
Plating or Flash Copper Plating)
Pure Silver, Highly
Conductive, no ‘missed spots’ of plating.
Incredible bond strength, bonds to all plastics and materials like dried
flowers, baby shoes, etc. Finished
plated surface can be lightly buffed. No
delaminating from surface. Fast
drying, ready to plate in 30 minutes. Beats
ALL other conductive paints – by a mile!
Micro fine surface, gives incredible detail on intricate mouldings.
No need to pre-wire the parts. Simply
spray, allow to dry, and then attach an alligator clip.
8oz
covers approx 20 - 30 sq ft
More Technical Information:
Silvaspray™ is a new silver conductive coating for use on plastic
substrates. It is unique in that it is formulated in very mild solvents that can
tolerate higher built in stresses which can be found in moulded parts, and
provides unequalled shielding at less than 0.5 mil (12.5 microns) dry film
thickness. The dried conductive film is extremely hard, tough and durable.
Contains no methyl ethyl ketone (MEK) or other strong solvents, which can attack
solvent sensitive substrates, such as polycarbonate and polycarbonate blends.
Silvaspray™ is supplied
as a concentrate, and it is designed with a fast drying solvent blend, which is
desirable in high volume production. Outstanding
Characteristics: Compatible with
sensitive plastics because of mild solvents.
Effective shielding at less than 0.5 mil (12.5 microns) dry film.
Contains no ketones, such as MEK, or other harsh solvents.100% Silver as the
conductive medium. Unmatched
conductivity superior to any other coating product.
Cost saving because of superior conductivity performance at thin films.
Excellent film cohesion. “Zero Tolerance” for loose particles in the film.
Passes U.L. requirements. Excellent
adhesion to most plastic substrates. Excellent
abrasion resistance. Supplied as a
viscous liquid for reduced settling. Minimal
overspray and dusting during application. No
rub off due to handling. Fast
drying.
Although Silvaspray is
formulated in mild solvents, the user must test the compatibility on the actual
moulded parts to determine its suitability for any specific application.
The following application
parameters should be followed for optimum properties:
Material should be stirred thoroughly before use.
Material should be incorporated into a re-circulating system.
Pressure in the system should be adjusted to produce sufficient flow
rates to ensure suspension of the metal. The
gun should be set as follows: Completely
shut off needle to the gun. Slowly
open needle to achieve a minimum wet film.
Adjust fan for part. Readjust
needle setting to ensure minimum wet coat.
By following the above procedures, a number of benefits will be achieved.
The optimum minimum film thickness will result in minimum cost per part. The
above techniques will produce a very smooth and bright appearance. Maximum
conductivity will also be achieved. Silvaspray™ dries rapidly.
Keep container closed. If skins develop,
do not attempt to dissolve – strain through a coarse filter. Clean equipment
after each use. Ethyl alcohol can be used to clean equipment. If strong solvents
are used, flush the system with ethyl alcohol before use.
SS39
Silvaspray 8oz Tin
£149.00